Proporcionamos equipos de sierra de alto rendimiento
Sawing machine saw out is oblique reasons and solutions
First, the blade problem
If the workpiece sawed out of the sawmill is cut diagonally, it may be due to the problem of the sawmill blade. If the sawmill blade is not installed correctly, the cutting angle of the workpiece will be deviated, which will lead to the workpiece cutting diagonally. In order to solve this problem, you can try to replace the blade, and ensure that the blade and clamping device in the same plane.
Second, the workpiece problem
If the workpiece sawed by the sawmill cuts diagonally, it is most likely due to problems with the workpiece itself. When the fixture is not tight enough or the workpiece can not be well maintained in the same plane, it will lead to workpiece cutting angle deviation. In order to avoid this problem, you need to make sure that the workpiece can be firmly clamped on the same plane.
Third, the jig problem
If the saw machine saw out of the oblique reason is not due to the blade or workpiece problems, then it may be due to the jig problem. When the fixture is not properly fixed or the technical parameters of the fixture is not good enough, the workpiece will not be stable enough. This causes the workpiece to be cut diagonally, affecting the accuracy and quality of the workpiece. In order to avoid this problem, you need to optimize the use of fixtures or replace the fixtures with more advanced ones.
Fourth, the sawmill itself
If none of the above problems exist, then the problem may be that the sawmill itself is not good enough or has some faults. Check whether the sawmill is in an ideal state to ensure that the sawmill real work stability and accuracy.
For the above problems, you can take the following solutions:
1, Replace the blade to ensure that the blade is in the same plane with the clamping device;
2, check and repair the clamping device failure;
3, Optimize the use of the clamping device or replace it with a more advanced one;
4, Ensure that the sawmill is in ideal condition to ensure stability and accuracy.
Previous page
Previous page